Bathroom Remodeling in Sherman Oaks
Sherman Oaks bathroom remodeling built around where the water goes: a sloped pan, a membrane behind the tile, sealed edges and a tested drain.
In an inland setting like the San Fernando Valley, the water in a Sherman Oaks bathroom comes from daily use: shower runoff, steam and the odd overflow. The build is aimed at where that water ends up. The floor slopes to the drain, a membrane behind the tile catches what the grout passes, and the wall edges are sealed so nothing wicks into the framing.
The pan and the drain
The base of the shower is formed with a mortar bed that falls toward the drain at 1/4 inch per foot of run, and a waterproof liner sits under it to carry whatever gets past the tile. The drain assembly has weep holes so the lower layer can empty as well. A tile-ready curb or a lowered threshold finishes the edge. The pan is flooded and watched before the tile covers it, and a drop in the level sends the crew back to the liner before any more work is stacked on top.
Walls, corners and openings
Above the base, the wall membrane runs from the pan flange up to the ceiling line in the shower, and every corner, seam, valve opening and niche is sealed with the system's own tape or sealant. Penetrations are the usual leak path, so the valve body and shower arm get gasketed. Outside the shower, a window sill or a door threshold gets flashing and a sloped surface so water drains outward. Good ventilation finishes the job by drying the condensation that remains.
About our bathroom remodeling workEverything we build in Sherman Oaks
Bathroom Remodeling in Sherman Oaks: questions
Yes in many cases, and the drain is the deciding detail. Where a shower floor can be recessed, a linear drain along one wall lets the slope run in a single direction, which suits large tiles. Where the floor cannot be lowered enough, a very low threshold is the fallback. Which one fits is settled when the structure is exposed.
A full assembly: a pan that slopes to the drain, a membrane bonded over it and up the walls, sealed corners, niches and valve openings, and a flood test before the tile. Tile and grout stay a finish surface while the membrane does the waterproofing. A shower in a Sherman Oaks house gets that same sequence.
Itemized by the trade involved: demolition and disposal, plumbing, waterproofing and pan, tile setting, glass or curtain, and fixtures. Framing changes appear separately when the floor has to be lowered. A shower door or curtain rod is listed so it does not get forgotten at the end.
Bathroom Remodeling in other cities
More work in Sherman Oaks
Planning work in Sherman Oaks?
Tell us about the lot and the job. A builder replies by phone or email to set up a visit.