Inglewood Decks & Patios, Footings Up
Inglewood decks and patios in treated framing, composite or hardwood boards and concrete pavers, chosen to hold up to hard sun and heavy use.
Hot-dipped galvanized or stainless connectors go on every hanger and bolt of an Inglewood deck we frame. Treated lumber corrodes ordinary plated steel, and a rusted hanger fails without warning. Above the frame, a capped composite board handles strong sun and dry wind with less fading and splitting than bare softwood, and it needs no yearly stain. Each choice is aimed at the part of the deck most likely to wear.
Framing and connector choices
Ground-contact treated lumber goes into posts and any beam within reach of soil, and above-ground grade goes into joists. Cut ends are brushed with preservative because treatment does not reach the core. Connectors match the treatment chemistry, which is why we avoid electro-plated hardware. Beams that span far can be glulam or steel where height or loads call for it. If the lot slopes, posts get bracing and the ledger is through-bolted into the house rim with structural fasteners sized by the engineer.
Patio surfaces at grade
For a level patio, the choices are poured concrete, pavers on a compacted base, or stone set in mortar. Pavers flex with small ground movement and can be lifted for repairs. Poured concrete needs control joints so cracks follow a line. Either surface is pitched away from the house and toward a drain. Where a patio meets a raised deck, the step between them is built to code rise and run, and the joint is detailed so water does not collect at the deck posts.
About our decks & patios workEverything we build in Inglewood
Decks & Patios in Inglewood: questions
No single number applies. A footing is sized for the load on its post and taken to soil firm enough to carry it, which the engineer confirms. If the yard has a grade, the low-side footings go deepest. The building department inspects the holes, so the depth is checked in person before concrete.
Fire rules depend on whether the parcel is in a mapped fire hazard severity zone. We check the official map for the exact address. Inside a mapped zone, decking and the underside meet ember-resistance standards. Outside one, the standard code covers it, and composite or fire-rated boards can still be chosen.
Area and height are both priced, alongside the material. Composite boards cost more per square foot than treated softwood, and stainless hardware more than galvanized. Height adds posts, bracing and footing depth. The quote names each material so you can trade one choice against another.
Decks & Patios in other cities
More work in Inglewood
Planning work in Inglewood?
Tell us about the lot and the job. A builder replies by phone or email to set up a visit.